Power Supply/Ignition Status

Inquiry and support for Freematics products
Post Reply
Thomas
Posts: 1
Joined: Thu Jan 12, 2017 7:30 pm

Power Supply/Ignition Status

Post by Thomas »

I try to simulate a trip with the OBD-II Emulator for a dongle of CalAmp. But the emulator seems not to connect properly to the dongle, as the Ignition LED never switch on. I tried to send ATACC1 via putty and also receive an ok. And I've tried to turn On/Off Ignition in the Emulator's GUI. Is there any hint for me, what I can do else?
In my car the Calamp Dongle works properly, so there must something within the communication between Emulator and Dongle.

Thanks in advance!
sagar0810
Posts: 6
Joined: Wed Jun 14, 2017 12:30 am

Re: Power Supply/Ignition Status

Post by sagar0810 »

I am also having same issue, can anyone help on that ?
Pressing Ignition ON doesn't work many times even though in console it shows that AT command executed successfully. Most of time response from Emulator to dongle take more then 5-6 minutes for Ignition ON command i.e ATACC1.
Post Reply