Freematics Forum

With the limited information that seems to be available, I would think using the PID_DISTANCE_WITH_MIL is your best bet for now, You would need to know the distance at which the fault codes where cleared and then add that to the read value, ie PID_DISTANCE_WITH_MIL + Offset

Hello Sune Did you end up solving this issue? I have been playing with these dataloggers for about a month, I have had nothing but troubles getting them to work, however the same logger, connected to the same USB will run with out the Brownout Error with the Datalogger project, but immediately error...

Hello Stanley, When I try to use BLE as the Networking method for the Telelogger code, I get an error about "'payload' was not declared in this scope", the only part of the code referencing payload is blePrint(payload); in the telelogger.ino code. Also, hopefully it is just a false positiv...

Hello damjani,
You will find that there is a pull down marked Target, this keeps going back to "Freematics One" instead of "Freematics One +", just check that it is correct before you press the build or com buttons.
Regards,
Bevan

Hello Stanley,

I will double check soon as I can get back to that PC, but it was using the latest version of Arduino Builder downloaded on the 18/11/2017 so pretty sure it was version 1.0.5, I hadn't noticed the version difference on this thread when looking for help at that time.

Regards,
Bevan

Hello Everyone, Has anyone had any luck or advice on setting up the Freematics ONE+ as a datalogger and then retrieving the data via the Bluetooth connection. I have tried the Telelogger sketch but have not been able to find a Bluetooth connection from a windows 10 laptop, it is possible I have not ...

Hello Stanley, I have been helping a friend with using the Freematics One+ and can confirm I had the same situation, when trying to program the Freematic after pressing the "COM3" button the output area of Audino Builder simply goes black and nothing further happens. It only occurred when ...