Page 2 of 2

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Posted: Sun Mar 11, 2018 3:56 am
by gospod
Anything new about sniff mode/ATMA?

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Posted: Tue Mar 27, 2018 1:08 am
by eric
still no news? :cry:

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Posted: Mon May 21, 2018 7:06 pm
by chipssunny
I'm working on a custom firmware to sniff CAN data from Tesla vehicles. I'll make a post here once it's finished.

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Posted: Tue Jun 12, 2018 4:48 am
by Watch
I simply signed up to also voice my support for the ability to sniff the CAN-BUS.

I have already have 2 other active CAN-BUS devices reading performance information. If the Freematics ONE+ was passive, I would have no concerns for dropped packets.

Freematics ONE+ is almost perfect for my needs. Real time data via sniffing with GPS.

Get on the ball Stanley.

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Posted: Sat Sep 01, 2018 4:38 am
by gospod
I have seen that this can do this: https://blog.freematics.com/2018/can-sn ... t-adapter/.
My question is, does I need just to update library or I need to buy new product? I think that now I have 2.0.

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Posted: Tue Jun 22, 2021 9:54 am
by cakira
Hi!
This thread is already old, but just to close it, I have a Freematics One+ and its co-processor firmware version is 2.3.
It already accepts the sniffer mode, through the command ATM1, as it can be seem in the example code.