Emulator command set: DTC7/DTCA not working

Inquiry and support for Freematics products
Post Reply
Alex4WAG
Posts: 7
Joined: Thu Dec 04, 2014 7:41 pm

Emulator command set: DTC7/DTCA not working

Post by Alex4WAG »

Hi There,

I have a problem with the emulator command set:

"ATSET DTC=P0105,P0106" is working fine and quitted with "OK"

"ATSET DTC7=P0105,P0106" and "ATSET DTCA=P0105,P0106" ist quitted with "ERROR".

Can somebody help?

Regards,

Alex.
stanley
Site Admin
Posts: 1018
Joined: Sat Mar 01, 2014 3:15 am

Re: Emulator command set: DTC7/DTCA not working

Post by stanley »

Your emulator must have J1850 support to work with mode 7 and mode A.
Alex4WAG
Posts: 7
Joined: Thu Dec 04, 2014 7:41 pm

Re: Emulator command set: DTC7/DTCA not working

Post by Alex4WAG »

Thanks, I am afraid mine does not. With J1850, will it support mode 07 and 0a with CAN protocol, too?
Is there any way to update my device?
Which J1850 protocol do I have to order to get mode 07 and mode 0a running with CAN?
stanley
Site Admin
Posts: 1018
Joined: Sat Mar 01, 2014 3:15 am

Re: Emulator command set: DTC7/DTCA not working

Post by stanley »

They are different hardware and not upgradable by software.
nitionic
Posts: 1
Joined: Wed Oct 18, 2017 8:51 pm

Re: Emulator command set: DTC7/DTCA not working

Post by nitionic »

Hi all, same question here, I am unable to set a pending DTC (mode 07), the button in the GUI is greyed out, and when trying it through the serial port I also receive 'ERROR’. Mode 03 DTC’s work fine. The emulator does have J1850 mentioned on the connector. Any clues? Would be great to get this working.
Alex4WAG
Posts: 7
Joined: Thu Dec 04, 2014 7:41 pm

Re: Emulator command set: DTC7/DTCA not working

Post by Alex4WAG »

Thanks, but which J1850 protocol do I have to order to get mode 07 and mode 0a running with CAN?
stanley
Site Admin
Posts: 1018
Joined: Sat Mar 01, 2014 3:15 am

Re: Emulator command set: DTC7/DTCA not working

Post by stanley »

Yes you can.
Alex4WAG
Posts: 7
Joined: Thu Dec 04, 2014 7:41 pm

Re: Emulator command set: DTC7/DTCA not working

Post by Alex4WAG »

You are offering two options: J1850 PWM and J1850 VPW. Which one do I need to get mode 07 and mode 0a running with the serial commands?
stanley
Site Admin
Posts: 1018
Joined: Sat Mar 01, 2014 3:15 am

Re: Emulator command set: DTC7/DTCA not working

Post by stanley »

Both will do.
Post Reply