Can not upload SW

Inquiry and support for Freematics products
Post Reply
damjani
Posts: 1
Joined: Fri Dec 29, 2017 7:06 am

Can not upload SW

Post by damjani »

Hello,

I have tried uploading few different examples from github (freematics-master -> firmware_v5). At the begginning it was
successful. After few attempts I get error

avrdude.exe: stk500_recv(): programmer is not responding
avrdude.exe: stk500_getsync() attempt 1 of 10: not in sync: resp=0xfb

and I can not upload anything.

What do you suggest? Can it be fixed or I send the HW back?
stanley
Site Admin
Posts: 1018
Joined: Sat Mar 01, 2014 3:15 am

Re: Can not upload SW

Post by stanley »

Please note V5 (Freematics ONE+) is not AVR based but ESP32 based. Apparently you are uploading to a AVR target (avrdude is the AVR uploader).
vk5bd
Posts: 7
Joined: Sun Nov 19, 2017 4:35 pm

Re: Can not upload SW

Post by vk5bd »

Hello damjani,
You will find that there is a pull down marked Target, this keeps going back to "Freematics One" instead of "Freematics One +", just check that it is correct before you press the build or com buttons.
Regards,
Bevan
Post Reply