One+ external canbus

Inquiry and support for Freematics products
Post Reply
barrythelion
Posts: 3
Joined: Tue Feb 23, 2021 8:29 am

One+ external canbus

Post by barrythelion »

Hi all,

Is it possible to connect the ONE+ to an external CANbus via the molex connector? I can't figure out from the schematic whether the pins go to the coprocessor or not. In my vehicle the OBD canbus is useless, you need to wire into separate bus connectors.

Thanks!
James.
stanley
Site Admin
Posts: 896
Joined: Sat Mar 01, 2014 3:15 am

Re: One+ external canbus

Post by stanley »

This is not possible. The molex connector can only be used for 3.3V GPIO, I2C or serial UART purposes.
Post Reply