Page 1 of 1

One+ external canbus

Posted: Sun Sep 12, 2021 7:41 am
by barrythelion
Hi all,

Is it possible to connect the ONE+ to an external CANbus via the molex connector? I can't figure out from the schematic whether the pins go to the coprocessor or not. In my vehicle the OBD canbus is useless, you need to wire into separate bus connectors.

Thanks!
James.

Re: One+ external canbus

Posted: Tue Sep 14, 2021 10:47 am
by stanley
This is not possible. The molex connector can only be used for 3.3V GPIO, I2C or serial UART purposes.