I have got the OBDIIUART V1 to work with our 2007 VW EOS car, but when I connect it to the VW transporter 2005 it does nothing. "connecting.."
I have looked into the OBD2UART.h and tried to force the KWS2000 proto, but still nothing..
Can anyone advise any other setting that could be implemented to allow it to communicate with the transporter?
the 2007VW and the 2005VW have always connected fine to VCDS via VAG-COM with the same protocol settings. What could cause an issue.
Any advice would be appreciated. Kind regards
Discussion about Freematics software, including Freematics Emulator GUI software, Freematics Arduino Builder etc.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests