Emulator replay CAN dump traffic

Discussion about Freematics software, including Freematics Emulator GUI software, Freematics Arduino Builder etc.
willluk
Posts: 1
Joined: Wed Mar 06, 2019 10:30 am

Emulator replay CAN dump traffic

Postby willluk » Wed Mar 06, 2019 10:37 am

Does anyone know if Freematics OBD-II Emulator can replay a CAN traffic dump (captured with CAN-Utils in GitHub)? Since CAN 11/29 are both supported, I assume these are simulated on pin 6 and 14 on the OBD-II connector? We would like to use the emulator to test software capturing CAN bus traffic. Thanks!!

Return to “Freematics Software”

Who is online

Users browsing this forum: No registered users and 4 guests