Issues using Cellular GNSS

Discussion about software developed by Freematics, including Freematics Builder and Freematics Emulator GUI
Post Reply
cmendes0101
Posts: 14
Joined: Wed Jul 29, 2020 1:06 pm

Issues using Cellular GNSS

Post by cmendes0101 »

Switching over to try out cellular GNSS seems to not work with getting latitude using telelogger. I'm testing using an antenna connected to the cellular module.

GNSS is active and the serial console shows GPS data being collected: [GPS] 32.XXXXXX -117.XXXXXX 0km/h Course:46 2020-10-30T22:55:20Z

within telelogger it appears to only get latitude. I tried to look over the code but not really sure why it acts different from the External vs Internal GNSS.

Anyone have this issue?
cmendes0101
Posts: 14
Joined: Wed Jul 29, 2020 1:06 pm

Re: Issues using Cellular GNSS

Post by cmendes0101 »

Nevermind, totally an issue on my side. The buffer became full right after adding lat when using the cellular GNSS. Console does print "Full" which I didn't notice was related.

The external GNSS performs better but I'm having GPS signal issues on multiple vehicles due to where the OBDII port is located so trying out other setups
Post Reply