Looks like a bug in finding port for bootloader

Discussion about software developed by Freematics, including Freematics Hub, Freematics Builder, Freematics Emulator GUI
Post Reply
tantan
Posts: 2
Joined: Tue Feb 23, 2021 6:57 am

Looks like a bug in finding port for bootloader

Post by tantan »

I am able to upload sketches in Arduino IDE fine. PlatformIO also work. I even tried AVRdude manually and it works if i use special reset procedure. I can also use tools like QMK toolbox ok.

But with Arduino Builder I have trouble . I get stuck on "Forcing reset using using 1200bps open/close on com4". I see the LED on the board blink every second or so for about 10 seconds and then get a message "no new port found".

Its not able to reset the board to get to the bootloader. Device manager does not refresh in the process so I know its not resetting.

If I go to command prompt and type: mode COM4 baud=1200 parity=n data=8 stop=1 the system does reset the port correctly and i see device manager react to the reset and it stays in dfu mode for 2-3 seconds and then it goes to normal mode.

Is there some bug in the reset code? I am using versions 1.0.13.
Post Reply