Freematic IDE and ESP32 OBD Kit

Discussion about software developed by Freematics, including Freematics Builder and Freematics Emulator GUI
Post Reply
Posts: 2
Joined: Tue Mar 02, 2021 8:36 pm

Freematic IDE and ESP32 OBD Kit

Post by »


I am new to audino and freeematics. I have a Freematics OBD kit with ESP32. I am trying to load a wifi sketch so I can communicate with OBD wirelessly. Looks like it compiles without problem, but results in an "error linking:

Here is the sketch:

Code: Select all

#include "WiFi.h" // ESP32 WiFi include
#include "WiFiConfig.h" // My WiFi configuration.
void ConnectToWiFi()
  WiFi.begin(SSID, WiFiPassword);
  Serial.print("Connecting to "); Serial.println(SSID);
  uint8_t i = 0;
  while (WiFi.status() != WL_CONNECTED)
    if ((++i % 16) == 0)
      Serial.println(F(" still trying to connect"));
  Serial.print(F("Connected. My IP address is: "));

I have configured the WiFiConfig.h with the correct credentials
. This is the IDE response:
Build Target: ESP32 (MCU: esp32 @ 240Mhz)
Library path: hardware/arduino/esp32/libraries/WiFi/src
Referenced libraries: [WiFi]

Compiling wifi.ino.cpp...

Using pre-compiled core file

Compiling library [WiFi]...
Processing hardware/arduino/esp32/libraries/WiFi/src
Compiling ETH.cpp...
Compiling WiFi.cpp...
Compiling WiFiAP.cpp...
Compiling WiFiClient.cpp...
Compiling WiFiGeneric.cpp...
Compiling WiFiMulti.cpp...
Compiling WiFiScan.cpp...
Compiling WiFiServer.cpp...
Compiling WiFiSTA.cpp...
Compiling WiFiUdp.cpp...

Linking all objects...

Error linking objects.

Additionally the following is my IDE basic settings:
ide_set.JPG (35.97 KiB) Viewed 3644 times
I have alos suspended the virus software during compile

Any help would be appreciated. Thanks
Post Reply