Reciveing Passive Information on the CAN-BUS (Not Querying)

Inquiry and support for Freematics products
gospod
Posts: 7
Joined: Thu Oct 26, 2017 6:39 am

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Post by gospod »

Anything new about sniff mode/ATMA?
eric
Posts: 7
Joined: Sun Nov 26, 2017 10:11 am

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Post by eric »

still no news? :cry:
chipssunny
Posts: 1
Joined: Mon May 21, 2018 7:05 pm

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Post by chipssunny »

I'm working on a custom firmware to sniff CAN data from Tesla vehicles. I'll make a post here once it's finished.
Watch
Posts: 3
Joined: Tue Jun 12, 2018 4:35 am

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Post by Watch »

I simply signed up to also voice my support for the ability to sniff the CAN-BUS.

I have already have 2 other active CAN-BUS devices reading performance information. If the Freematics ONE+ was passive, I would have no concerns for dropped packets.

Freematics ONE+ is almost perfect for my needs. Real time data via sniffing with GPS.

Get on the ball Stanley.
gospod
Posts: 7
Joined: Thu Oct 26, 2017 6:39 am

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Post by gospod »

I have seen that this can do this: https://blog.freematics.com/2018/can-sn ... t-adapter/.
My question is, does I need just to update library or I need to buy new product? I think that now I have 2.0.
cakira
Posts: 1
Joined: Tue Jun 22, 2021 9:51 am

Re: Reciveing Passive Information on the CAN-BUS (Not Querying)

Post by cakira »

Hi!
This thread is already old, but just to close it, I have a Freematics One+ and its co-processor firmware version is 2.3.
It already accepts the sniffer mode, through the command ATM1, as it can be seem in the example code.
Post Reply