I have been having different issues for about the past week with getting my Freematics One+ device up and running. I was able to clean up the majority of the issues, but I haven't been able to solve this brownout issue when trying to upload and compile the datalogger sketch. I have attached pictures of the config window after I load datalogger along with a picture showing open serial monitor displaying the brownout error. I have tried plugging the USB into my docking station because I read my laptop may not be supplying enough power. I still had no luck there. Are there any solutions to ensure that that the USB is supplying enough power? Or is there a different issue at play here. Any assistance or guidance will be greatly appreciated!
*Pictures are small due to file size
Discussion about Freematics software, including Freematics Emulator GUI software, Freematics Arduino Builder etc.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests