Nano Kit, Can't Upload

Inquiry and support for Freematics products
AustinBob
Posts: 3
Joined: Sun May 06, 2018 9:24 am

Nano Kit, Can't Upload

Postby AustinBob » Sun May 06, 2018 9:44 am

I am having a hard time getting anything to upload to the Nano; even blink. I'm on Windows and it sees it attached as COM6. It sees that it is a CH340. But no matter what programmer I select in the IDE, it gets an error. (I am able to upload to an Uno I have sitting here.)

Uploading with AVR ISP
Using Port : COM6
Using Programmer : stk500v1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x03

Uploading with AVRISP MKII
Using Port : usb
Using Programmer : stk500v2
An error occurred while uploading the sketch
avrdude: usbdev_open(): did not find any USB device "usb" (0x03eb:0x2104)

Just an Upload
Using Port : COM6
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xf2

stanley
Site Admin
Posts: 695
Joined: Sat Mar 01, 2014 3:15 am

Re: Nano Kit, Can't Upload

Postby stanley » Mon May 07, 2018 10:55 pm

Did you connect OBD adapter to the nano board when uploading?

AustinBob
Posts: 3
Joined: Sun May 06, 2018 9:24 am

Re: Nano Kit, Can't Upload

Postby AustinBob » Tue May 08, 2018 1:54 am

No I did not. I finally got it to upload using the "ATmega328P (Old Bootloader)" processor and the "AVRISP mkII" programmer. Now to try and add the Toyota PID for transmission temp. :)

Thanks.

AustinBob
Posts: 3
Joined: Sun May 06, 2018 9:24 am

Re: Nano Kit, Can't Upload

Postby AustinBob » Tue May 08, 2018 11:03 pm

It was not connected. I was able to get it working by using a different processor. The "ATmega329P (Old bootloader)" is the one that worked. The programmer was still the AVRISP mkii.

Now I need to figure out how to add the PID for the Toyota transmission. :)

Thanks!


Return to “Freematics Products”

Who is online

Users browsing this forum: No registered users and 9 guests