Search found 896 matches

by stanley
Sun Sep 26, 2021 10:40 pm
Forum: Freematics Products
Topic: Possible reason for ONE+ (H) to stop sending data
Replies: 9
Views: 469

Re: Possible reason for ONE+ (H) to stop sending data

Is it possible for you to retrieve serial output before hanging up?
by stanley
Sat Sep 25, 2021 6:24 pm
Forum: Freematics Software
Topic: SAE J1939 NOT READ
Replies: 4
Views: 184

Re: SAE J1939 NOT READ

Which make of trucks have you tested on?
by stanley
Thu Sep 23, 2021 11:37 am
Forum: Freematics Products
Topic: model H not read j1939 protocol
Replies: 3
Views: 206

Re: model H not read j1939 protocol

I see you have modified the FreematicsOBD.cpp and added some code. Please use the original. Please don't think you are working with ELM327 although it appears to be. Also we have stated on the product page that only broadcast traffic of J1939 can be obtained.
by stanley
Thu Sep 23, 2021 11:31 am
Forum: Freematics Products
Topic: Possible reason for ONE+ (H) to stop sending data
Replies: 9
Views: 469

Re: Possible reason for ONE+ (H) to stop sending data

Please enable RESET_AFTER_WAKEUP in case there is lockup issue.
by stanley
Mon Sep 20, 2021 8:53 pm
Forum: Freematics Products
Topic: model H not read j1939 protocol
Replies: 3
Views: 206

Re: model H not read j1939 protocol

Since we don't use any ELM327 chips, we have our way of J1939 traffic monitoring. Use example code j1939_monitor.
by stanley
Mon Sep 20, 2021 8:51 pm
Forum: Freematics Products
Topic: Possible reason for ONE+ (H) to stop sending data
Replies: 9
Views: 469

Re: Possible reason for ONE+ (H) to stop sending data

Have you enabled RESET_AFTER_WAKEUP in config.h?
by stanley
Tue Sep 14, 2021 10:48 am
Forum: Freematics Products
Topic: Cannot Monitor CANBUS Data
Replies: 13
Views: 13114

Re: Cannot Monitor CANBUS Data

CAN sniffing/monitoring is only supported by ONE+.
by stanley
Tue Sep 14, 2021 10:47 am
Forum: Freematics Products
Topic: One+ external canbus
Replies: 1
Views: 177

Re: One+ external canbus

This is not possible. The molex connector can only be used for 3.3V GPIO, I2C or serial UART purposes.
by stanley
Mon Sep 06, 2021 5:36 pm
Forum: Freematics Products
Topic: Freematics One+ compatibility to iso15765
Replies: 3
Views: 368

Re: Freematics One+ compatibility to iso15765

At the moment we don't have any product supporting this.
by stanley
Mon Sep 06, 2021 5:33 pm
Forum: Freematics Products
Topic: Unable to connect to CELL
Replies: 5
Views: 345

Re: Unable to connect to CELL

Which model of ONE+. Do you have cellular module?